In order to give you better service we use cookies. By continuing to browse the site you are agreeing to our use of cookies.

Audix Contractor (installed) microphones.

Audix microphones are preferred by installers because they consistently provide superior fidelity, durability, versatility, and value; with ease of installation.

Filter & sort
Number of articles 3
M3 Tri-element hanging ceiling microphone White
The M3 is an innovative, tri-element hanging microphone system designed for applications where aesthetics, sound quality, and ease of installation are critical. The M3 is an ideal audio capture solution for video conferencing, distance learning, courtroom activities, and surgical procedures. It can also be used for ambient room miking and surveillance.
The M3 incorporates three phase coherent hypercardioid capsules with tailored frequency response optimized for speech intelligibility. This is accomplished by minimizing frequencies caused by noise, vibration, paper shuffling, keyboard strokes, fans, and heating /air conditioning. Low noise preamp circuitry is employed for highest possible signal to noise and studio quality sound. A high-quality silicone jacketed microphone cable ensures a balanced, shielded signal and a very clean look. Electronics above the ceiling are housed within a plenum rated junction box and cable connections are made via an RJ45 connector embedded within a proprietary brass housing for an airtight seal.
The M3 connects to the input of a mixer or dsp console via a breakout cable (provided). The breakout cable consists of a female RJ45 connector that terminates in either three terminal block or XLR connectors. A variety of optional shielded CAT7 cable lengths (from plenum rated junction box to break out cable) are available.
Installing the M3 requires drilling just one 5/8-inch hole in the ceiling, with no additional tools needed. The M3 mounting hardware easily adjusts the cable hanging height up to four feet from the ceiling surface without removing ceiling tiles. A wire safety cable provides additional seismic restraint.
100% RF shielding and immunity
Gold diaphragm condenser capsules with studio quality sound
Low impedance design allows for extremely long cable runs (if required) without cross talk or interference
Frequency and pattern tailored for voice clarity and rejection of extraneous noise
Evenly dispersed sound with undetectable phase
High-quality silicone jacketed microphone cable with adjustable length and position
Plenum rated junction box with RJ45 connector
All visible components of the microphone and cable are same color: charcoal or white
TAA compliant
Very high output, low self-noise
Easy to install
- Zone Capture
- Video Conferencing
- Distance Learning
- Hospital and medical procedure
- Courtroom
- Ambient room miking

Type Condenser
Polar Pattern Hypercardioid
Frequency Response 30 Hz - 19kHz (Tailored)
Impedance 150 Ohms
Sensitivity 34 mV / Pascal @ 1k
MG15HC, 15" Gooseneck Condenser Microphone 38 cm
The MG Series gooseneck system is equipped with a sophisticated dual preamp circuitry – one circuit located in the capsule housing and the other built into the base of the XLR. This circuitry is internally balanced, insuring the audio path will be isolated from hum and noise. In addition, this circuitry provides protection from RF interference and spurious emissions from cell phones and wireless GSM devices.
The MG12, MG15 and MG18 are professional miniature gooseneck condenser microphones designed for applications such as podium, presentation, meetings and teleconferencing. The MG mics are designed with a uniformly controlled cardioid polar pattern, helping to isolate the speaker from ambient noise. These models are also available in a hypercardioid polar pattern. With a wide frequency range of 60 Hz - 19 kHz, the MG provide natural sound with exceptional vocal response.
- Pulpit, Podium
- Boardroom
- Video Teleconferencing
Type Pre-polarized Condenser
Polar Pattern Cardioid or Hypercardioid (HC)
Frequency Response 60Hz - 19kHz
Impedance 150 Ohms
Sensitivity @ 1k 38 mV/Pa, 32 mV/Pa (HC)
MB8450-HC MicroBoom-84 Hypercardioid Microphone
Audix MB8450HC = 127 cm long carbon fiber boom, clutch assembly & with M1250BHC hypercardioid mic

Ensemble vocal
Orchestral zone miking
Location recording
Conference room
Mic stand adapter with thumbscrew and wing nut adjustments (MCBOOM)
and 25’ shielded mic cable.
Pedestal mic stand adjustable 13-20 inches (MBSTAND)
50’ shielded mic cable. Mini-XLRf - XLRm (CBLM50)
MODELS AVAILABLE AS A SYSTEM* (includes microphone):
MB5050 - MICROBOOM50 with M1250B cardioid mic
MB5050HC - MICROBOOM50 with M1250BHC hypercardioid mic
MB5055 - MICROBOOM50 with M1255B high ouput cardioid mic
MB5055HC - MICROBOOM50 with M1255BHC hypercardioid mic
MB8450 - MICROBOOM84 with M1250B cardioid mic
MB8450HC - MICROBOOM84 with M1250BHC hypercardioid mic
MB8455 - MICROBOOM84 with M1255B high ouput cardioid mic
MB8455HC - MICROBOOM84 with M1255BHC hypercardioid mic

The product has been added to your shopping cart Show shopping cartCheckout